12
DataDock Storage Systems
4.
If the DataDock is the only SCSI device being connected to the Wide SCSI adapter card, insert the
SCSI terminator into the top DataDock SCSI connector.
Wide terminator.
Wide DataDock with SCSI cable, terminator and power cord installed.
5.
If one or more additional SCSI peripherals will be connected to the DataDock, connect the
devices together and connect a terminator to the last device in the chain.
6.
Set the SCSI ID switches on the rear of the DataDock to ID numbers that are not in use by the
other SCSI devices on the same bus. The SCSI ID number is changed by pressing the switch’s
push buttons.
In Macintosh systems, ID 0 and 3 are usually assigned to the internal hard disk and CD-ROM drive,
respectively. In IBM PC systems, ID 0 and 1 are usually reserved by the boot drives. In both systems, ID 7
is reserved for the system and cannot be used.
!
Two SCSI devices sharing the same SCSI ID will cause problems to occur.
SCSI ID switch.
Push button selectors
