Microhard Systems pMDDL5824, Operating Manual

Page: 94 / 117

© Microhard 94
5.0 AT Command Line Interface
5.3 Supported AT Commands
Basic AT Commands
AT Command Description Syntax Effect
AT AT echo OK AT <enter> Immediate
ATE0 Disable echo ATE0 <enter> Immediate
ATE1 Enabled local echo ATE1 <enter> Immediate
ATH Show a list of previously run commands ATH <enter> Immediate
ATL Show a list of all available AT Commands ATL <enter> Immediate
AT&R Read modem profile to editable profile.
(Reserved)
AT&R <enter> Immediate
AT&V Read modem active profile AT&V <enter> Immediate
AT&W Enable configuration changes that have been
entered
AT&W <enter> Immediate
ATA Quit. Exits AT command session and returns to
login prompt
ATA <enter> Immediate
ATO Quit. Exits AT command session and returns to
login prompt
ATO <enter> Immediate
Administrative AT Commands
AT Command Description Syntax Effect
AT+MADISS Get/Set discovery service used by the modem AT+MADISS[=<Mode>[,<Port>]]
Mode:
0 - Disable
1 - Discoverable
Port:
1 to 65535. Default is 20097
AT&W
AT+MASNMP Get/Set SNMP service AT+MASNMP[=<Mode>[,<ROCommunity>,<RWCommunity>,<Port>,<Version>]]
<Mode>:
0 - Disable
1 - Enable
<ROCommunity>: Read Only Community Name
1 to 32 characters
<RWCommunity>: Read Write Community Name
1 to 32 characters
<Port>: Listening Port
0 to 65535. Default is 161
<Version>: SNMP version
1 - Version 1
2 - Version 2
3 - Version 3 (Use AT+MASNMPV3 to set Authentication and Privacy parameters)
AT&W
AT+MASNMPV3 Get/Set SNMP Version 3 AT+MASNMPV3=<UserName>,<RWLimit>,<AuthLevel>[,<Auth>,<AuthPassword>[,<Privacy>,
<PrivacyPassword>]]
<UserName> : V3 User Name
1 to 32 characters
<RWLimit> : V3 User Read Write Limit
0 - Read Only
1 - Read Write
<AuthLevel> : V3 User Authentication Level
0 - NoAuthNoPriv
1 - AuthNoPriv
2 - AuthPriv
<Auth> : V3 Authentication Protocol
0 - MD5
1 - SHA
<AuthPassword> : V3 Authentication Password
5 to 64 characters
<Privacy> : V3 Privacy Protocol
0 - DES
1 - AES
<PrivacyPassword>: V3 Privacy Password
5 to 64 characters
Usage:
NoAuthNoPriv : AT+MASNMPV3=<UserName>,<RWLimit>,0
AuthNoPriv : AT+MASNMPV3=<UserName>,<RWLimit>,1,<Auth>,<AuthPassword>
AuthPriv :
AT+MASNMPV3=<UserName>,<RWLimit>,2,<Auth>,<AuthPassword>,<Privacy>,<PrivacyPassword>
AT&W