© Microhard
14
2.0
Quick Start
To reset to factory
defaults, press and
hold the CONFIG for 8
seconds with the
pMDDL5824 powered
up. The pMDDL5824
will reboot with factory
default settings.
This QUICK START guide will walk you through the setup and configuration of a few
basic applications. The QUICK START will rely on the
WebUI
for configuration. This
walkthrough also assumes the units used are installed in microhard interface/
development boards or custom boards that allow access to the LAN port. See the
appropriate section for pin
-
outs.
Note that the units arrive from the factory with a Radio Configuration of
‘
Master
’
and the Local Network setting configured as
‘
Static
’
(IP Address
192.168.168.1
,
Subnet Mask 255.255.255.0). DHCP is enabled by default, and will assign an IP to a
connected device or computer with DHCP enabled.
2.1
Getting Started
✓
Connect the appropriate Antenna(s) to the pMDDL5824.
✓
Connect and/or apply a suitable power source to the unit. Allow the unit to boot
up fully, the CPU LED (Blue) should be on in a solid state
✓
Connect A PC to the
LAN
port of the pMDDL5824 Dev Board, using an Ethernet
Cable.
✓
The PC must have its Network Setting (TCP/IP Properties) set to DHCP (The mo-
dem will assign a IP address to you), or STATIC with an IP Address of (e.g.)
192.168.168.10 and a Subnet Mask of 255.255.255.0.
✓
Open a Browser Window and enter the IP address 192.168.168.1 into the ad-
dress bar.
The factory default
network settings:
IP: 192.168.168.1
Subnet: 255.255.255.0
LAN
192.168.168.1
Summary of Contents for pMDDL5824
