© Microhard Systems Inc.
45
4.0 WebUI Configuration
PPP Status
This option allows the operation of PPP.
Disable /
Enable
Values (selection)
NAT (Network Address Translation)
When NAT is enabled internal addresses are not visible to external
networks. When disabled the router does not perform any address
translation on the packets passing through it.
Disable /
Enable
Values (selection)
Network Data Mode
When set to Automatic the modem will automatically decide on the best
signal to connect to, in some cases this may be 2G. When set to
3G Only,
the modem will continually try to connect to 3G, the same for 2G only.
Once set to operate in a specific technology, a user can then select which
frequencies within that technology to use. It is recommended to be careful,
as if no useable frequency/technology (3G/2G) is available, the modem will
not connect.
Automatic
3G Only
(1900/850/900/2100/1700)
2G Only
(850/900/1800/1900 MHz)
Values (selection)
Access Point Name (APN)
The (Access Point Name) APN is required and assigned by the wireless
carrier. A Carrier will have different APNs for different service types (Static
vs Dynamic etc).
Carrier dependant
Values (String)
SIM Pin
It is possible to have a Pin number associated with a SIM card that is
required to use the SIM card on a device. If the installed SIM card has
been set up with a SIM Pin, enter the number here.
Carrier dependant
Values (String)
Carrier ID
In Manual Carrier mode, select the desired carrier from the list of available
carriers. In fixed mode, enter the Carrier ID.
Varies
Values
