© Microhard Systems Inc.
14
2.0 Quick Start
This QUICK START guide will walk you through the setup and process required to
access the WebUI configuration window and to establish a basic wireless connection
to your carrier.
Note that the units arrive from the factory with the Local Network setting configured
as ‘Static’ (IP Address 192.168.0.1, Subnet Mask 255.255.255.0, and Gateway
192.168.0.1), in DHCP server mode. (This is for the Ethernet Adapter on the back
of the IPn3G unit.
2.1 Installing the SIM Card
Before the IPn3G can be used on a cellular network a valid
SIM Card
for your
Wireless Carrier must be installed. Insert the SIM Card into the slot as shown
below.
2.2 Getting Started
Connect the Antenna’s to the applicable
ANTENNA
jack’s of the IPn3G.
Connect the Phoenix-Type Connector to the power adapter as shown below and
apply power to the
unit.
SIM Card Slot
To reset to factory
defaults, press and
hold the CFG button
for 8 seconds with the
IPn3G powered up.
The LED’s will flash
quickly and the IPn3G
will reboot with factory
defaults.
Main Antenna (SMA)
(GPS & Diversity not shown)
Use the MHS-supplied
power adapter or an
equivalent power
source
.
RS485/422
TxB
-
TxA -
RxB -
RxA -
GND -
Vin+
-
USB
DIA
GN
OS
TIC
RF
RSS
I
SG
NL
STA
TU
S
CO
NFI
G
micr
ohar
d SY
STE
MS
INC
.
SIM
CAR
D
