IM30-CV
Doc. N° MO-0150-ING
Rev.
1
Date
14.07.2003
Copyright 2010 - Microener
Firmware:
1.0X
Pag
2
di
24
INDEX
1 General utilization and commissioning directions
_____________________________________________
3
1.1 Storage and transportation_____________________________________________________________ 3
1.2 Installation__________________________________________________________________________ 3
1.3 Electrical connection__________________________________________________________________ 3
1.4 Measuring inputs and power supply______________________________________________________ 3
1.5 Outputs loading______________________________________________________________________ 3
1.6 Protection earthing___________________________________________________________________ 3
1.7 Setting and calibration_________________________________________________________________ 3
1.8 Safety protection_____________________________________________________________________ 3
1.9 Handling___________________________________________________________________________ 3
1.10 Maintenance________________________________________________________________________ 4
1.11 Fault detection and repair______________________________________________________________ 4
2 General characteristics and operation
_______________________________________________________
4
2.1 Power supply________________________________________________________________________ 4
3 Controls and measurements
_______________________________________________________________
5
4 Signalization
____________________________________________________________________________
6
5 Output relays
___________________________________________________________________________
7
6 Serial communication
____________________________________________________________________
7
7 Digital inputs
____________________________________________________________________________
8
8 Test
___________________________________________________________________________________
8
9 Keyboard and display operation
____________________________________________________________
9
10 Reading of measurements and recorded parameters
___________________________________________
10
10.1 ACT. MEAS (Actual measure)_________________________________________________________ 10
10.2 MAX VAL (Max Value) _____________________________________________________________ 10
10.3 LASTTRIP (Last trip) _______________________________________________________________ 11
10.4 TRIP NUM (Trip number) ____________________________________________________________ 11
11 Reading of programmed settings and relay’s configuration
_____________________________________
11
12 Programming
___________________________________________________________________________
12
12.1 Programming of functions settings_______________________________________________________ 12
12.2 Programming the configuration of output relay______________________________________________ 14
Note 1 : Function I<____________________________________________________________________ 15
Note 2 : Breaker Failure Protection ________________________________________________________ 15
Note 3 : Circuit breaker status detection ____________________________________________________ 15
Note 4 : Wait time for the reenergization of the capacitors ______________________________________ 15
Note 5 : Setting of the function for inherent unbalance compensation of the capacitors _______________ 15
13 Manual and automatic test operation
________________________________________________________
16
13.1
Mode “TEST PROG” subprogram W/O TRIP_______________________________________________ 16
13.2
Mode “TEST PROG” subprogram With TRIP_______________________________________________ 16
14 Maintenance
____________________________________________________________________________
16
15 Power frequency insulation test
____________________________________________________________
16
16 Electrical characteristics
__________________________________________________________________
17
17 Connection diagram
(Standard Output) ______________________________________________________
18
17.1 (Double Output)____________________________________________________________________ 18
18 Wiring the serial communication bus
_______________________________________________________
19
19 Change phase current rated input 1 or 5A
___________________________________________________ 19
20 Overall dimensions
______________________________________________________________________
20
21 Time current
____________________________________________________________________________
21
22 Direction for pcb’s draw-out and plug-in
_____________________________________________________
22
22.1 Draw-out___________________________________________________________________________ 22
22.2 Plug-in_____________________________________________________________________________ 22
23 Keyboard operational diagram
_____________________________________________________________
23
24 Setting’s form
___________________________________________________________________________
24
