http://www.microcyber.cn/en
~ 29 ~
Figure 5.56 Type Selection
2.
Select the value that needs to be modified, then click apply to save the modified value.
5.5.8.2
Unit
1.
select "Detailed Design"->"Sensor"-> drop-down box corresponding to"Unit", as shown in Figure 5.57
Figure 5.57 Unit selection
2.
Select the value that needs to be modified, then click apply to save the modified value.
5.5.8.3
Upper limit of sensor range
1.
Select "detailed Design"->"Sensor"-> drop-down box corresponding to"Sensor range limit", as shown in
Figure 5.58
Figure 5.58 Upper Range Selection of Sensor Range
2.
Enter the modified value, then click apply to save the modified value.
5.5.8.4
Lower limit of sensor range
1.
Select "detailed Design"->"Sensor"-> drop-down box corresponding to"sensor range limit", as shown in
Figure 5.59
Figure 5.59 Selection of Lower Range Limit of Sensor Range
2.
Enter the modified value, then click apply to save the modified value.
5.5.8.5
Minimum span
1.
Select "Detailed Design"->"Sensor"-> the drop-down box corresponding to"bottom span", as shown in
Figure 5.60
