Microcom 410, Operator'S Manual

Page: 98 / 104

Printer Commands Chapter 5
))))))))))))))))))))))))))))))))))))))))))))
))))))))))))))))))))))))))))))))))))))))))))
410 Operators Manual 92
39 Auto-Size Label: Section 5.3.3.
0 Clears the use of auto-size values set by ^A1^D39.
1 Uses the values obtained for the variables instead of what the user supplies in the
header of the format file.
2 Automatically sizes the label and displays on the screen the values for the size
variables.
3 Same as ^A2^D39, but prints the values on a label, instead of on the screen.
40 Clear Commands 41-51.
XX 41 Load number of fields in layout (HFM): Preceded by ^A.
XX 42 Load label width in dots (LXS): Preceded by ^A.
XX 43 Load label height in dots (LSY): Preceded by ^A.
XX 44 Load web size in dots (WEB): Preceded by ^A.
XX 45 Load gap size in dots (GAP): Preceded by ^A.
XX 46 Load print speed (DPS): Preceded by ^A.
XX 47 Load label control byte (LCB): Preceded by ^A.
XX 48 Load number of steps to activate gap detector (AGD): Preceded by ^A.
XX 49 Load number of steps past gap (SPG): Preceded by ^A.
XX 50 Load X direction offset (OFX): Preceded by ^A.
XX 51 Load Y direction offset (OFY): Preceded by ^A.
XX 54 Send Saved Format File to Serial Port: ^A selection which one (1-8). Section
5.3.6.
XX 55 Select ROM Label Layout: Select from the ROM power-up layouts. ^AXX
ranges from 1 to 8.
56 Select User Defined Layout: Signals to the printer the end of the label fields and
precedes the text fields in a format file.
57 Enter Label Format Mode: This tells the printer that information for a label is
following.
XX 58 Process Saved Format: ^A selects which one (1-8). Section 5.3.6.
XX 59 Save Format File: ^A selects which one (1-8). Section 5.3.6.