Microcom 410, Operator'S Manual

Page: 44 / 104

Printer Commands Chapter 5
))))))))))))))))))))))))))))))))))))))))))))
))))))))))))))))))))))))))))))))))))))))))))
410 Operators Manual 38
^A ^D COMMAND
21 Change SW1: Software dip switch #1. The dip switches are the only commands
that do not use the ^A parameters. Instead, they use a ^AB sequence followed by
an 8 digit 0 or 1 code.
For example: ^AB10101011^D21<CR> will configure the printer for a text
equivalent enquiry response, accept control codes, even parity, disable parity,
disable echo, 8 data bits and enable XON/XOFF flow control.
12345678
^ABxxxxxxxx
*******.Q
1=XON/XOFF Enable, 0=Disable
******.)Q
1=8 Data Bits, 0=7 Data Bits
*****.))Q
1=Echo Enable, 0=Disable
****.)))Q
1=No Parity, 0=Enable Parity
***.))))Q
1=Odd Parity, 0=Even Parity
**.)))))Q
1=Ignore Control Codes, 0=Accept
*.)))))))))),
.)))))))))),*
Enquiry Response
00 = Control Codes
10 = Text Equivalent
11 = ^ Equivalent
Position:
1,2 Enquiry Response: This determines what the printer will send back in response
to an enquiry. See chapter 5.
3 Control Codes: This switch setting will allow or disallow printer response to
control codes (below 20h).
4 Parity: Selects either even or odd parity error checking.
5 Enable Parity: Enables or disables parity error checking.
6 Echo: If this feature is enabled, the printer will echo all received characters to the
serial port.
7 Data Bits: Choose 7 or 8 bit data.
8 XON/XOFF: Enable or disable XON/XOFF software handshaking. Clear to Send
(CTS) hardware handshaking is always enabled.