eFuse controller for accessing the eFuse contents, the user must enter the valid arguments for eFuse
configuration.
6.2.
Command Syntax:
EfuseBlockProgram.exe <Bank No> <Block No> <Reg Value in
HEX> -v
.
•
Bank No
: Range from 0 to 5
•
Block No
: Range from 0 to 3
•
Reg Value
: eFuse to be configured in Hex
•
-v
: For verification of a programmed block
6.3.
To enable the ATBTLC1000 UART hardware flow control 4-wire mode, Bank-5 and Block-3 must be
written as “10000000” (inputs are in
hex
). The example write configuration to enable the hardware
flow control is shown in following figure.
Figure 9-5. Writing eFuse Values
ATBTLC1000
Hardware Flow Control for 4-Wire Mode eFuse ...
©
2019 Microchip Technology Inc.
User Guide
DS50002640B-page 80