Figure 9-3. Invoking Help Information
5.
Reading eFuse value:
5.1.
Command Syntax:
EfuseBlockProgram.exe –v <Bank No> <Block No>
.
•
Bank No
: Range from 0 to 5
•
Block No
: Range from 0 to 3
•
-v
: For verification of a programmed block
Note:
For the ATBTLC1000 UART hardware flow control 4-wire mode, Bank-5 and Block-3 are
configured.
5.2.
To enable the ATBTLC1000 UART hardware flow control eFuse configuration, use command
EfuseBlockProgram.exe –v 5 3
. The example output shown in following figure is for reading
the eFuse.
Figure 9-4. Reading eFuse Values
6.
Writing and verifying the ATBTLC1000 eFuse value:
6.1.
When writing the data to eFuse, the data written can never be changed (that is, if a value '1' is written
to a specific eFuse, those contents can never be reverted back to its original value. To configure the
ATBTLC1000
Hardware Flow Control for 4-Wire Mode eFuse ...
©
2019 Microchip Technology Inc.
User Guide
DS50002640B-page 79