14
Locate the 1/2” EVA vapor hose supplied with the kit.
Starting on one half of the tool bar, connect the 1/2” hose
to the outside steel vapor tube. Route the hose up the
shank and along the tool bar frame to the inside steel
vapor tube. Allow enough extra hose to avoid kinking at
hinge points. Cut the hose to length and attach to the
inside steel vapor tube. Install a 1/2” x 3/4” x 1/2” tee fitting
approximately halfway along this hose between the outside
and inside steel vapor tubes.
See Illustration 9 below.
Repeat the same procedure for the steel vapor tubes on
the other half of the tool bar. Secure all hoses with properly
sized hose clamps. Secure the hoses to the tool bar frame
with cable ties.
Locate the 3/4” EVA hose supplied with the kit. Connect
to one of the 1/2” x 3/4” x 1/2” tee fittings and route along
the tool bar frame to other 1/2” x 3/4” x 1/2” tee fitting. Cut
to length and install on the tee fitting. Allow enough extra
hose to avoid kinking at hinge points. Now install a 3/4”
x 3/4” x 3/4” tee fitting approximately halfway along this
hose (center of the tool bar) between the other two tee
fittings. Using an appropriate length 3/4” hose, connect this
tee fitting to the vapor tube connection on the Liquifer™
plumbing panel. Secure all hoses with properly sized hose
clamps. Secure the hoses to the tool bar frame with cable
ties.
Liquifier™ - Vapor Line Installation
FOR ALL NH3 KITS
Weld the steel vapor tubes to the back of your liquid
tubes. All electronic equipment, including the console and
radar speed sensor,
MUST BE DISCONNECTED BEFORE
WELDING ON EQUIPMENT.
The four steel vapor tubes
should be evenly spaced across the applicator (two per
side) and installed so that only their wear resistant surface
contacts the soil. Mount the tubes just high enough to
avoid plugging.
See Illustration 10 below.
VAPOR TUBES
WEAR RESISTANT
SURFACE
GROUND LEVEL
½” Vapor Hose
Liquifier™
Heat Exchanger
Steel Vapor Tubes
½” Vapor Hose
Vapor Outlet
½” Vapor Hose
½” Vapor Hose
¾” Vapor Hose
½” X ¾” X ½” Tee
½” X ¾” X ½” Tee
Steel Vapor Tubes
¾” Vapor Hose
Vapor Outlet
Installation
(cont.)
llustration 10
llustration 9
