micro-trak FLOWTRAK II, Reference Manual

Page: 14 / 44

14
Installation
(cont)
Remote Run/Hold
(Requires Kit # 01535)
Lift Wheel Mounting
Hydraulic Cylinder Mounting
Remote Run sensor on hydraulic cylinder. Magnet and sensor
are in line when equipment is lowered and operating.
The run/hold sensor cable has a BLACK body and mates with
the main har ness ca ble having a GRAY cable tie near the 3-pin
M/P con nec tor. Make certain that you install the correct sen-
sor cable and connect it to the correct connector on the main
harness.
IMPORTANT:
If not using Run/Hold cable for remote use, make certain a
dust cover with jumper is installed.
• The basic idea is to attach a magnet to a lever or some
part of the equipment that moves when the im ple ment
is raised and lowered. The Hall-effect Run/Hold sensor is
sensitive only to the south pole of the magnet. Install
the magnet with the dashed line facing the sensor.
When the mag net is away from the sen sor, the con sole
will be in HOLD and the area and distance counting
functions will be disabled. NOTE: The run/hold kit
includes a 5’ sensor cable and 10’ extension. You may
re quire additional extension cables which are avail able
in 5 ft. (1.5 m), 10 ft. (3 m), 15 ft. (4.5 m), 20 ft. (6 m) and
25 ft. (7.6 m) lengths.
• You may also use a toggle or other type switch. Sim ply
cut the black jumper wire in the dust cover and splice on
an appropriate length of wire to reach your switch. Do
not connect to a switch with power.
When switch is closed, console is in RUN. When the switch is
open, the console is in HOLD.
Run
Position
Hold
Position
Sensor
(Black body)
Magnet
North
South
Sensor (Black body)
1/8” to 3/8”
(6 mm to 13 mm)
when wheels are up
Magnet
South
North
Run/Hold Sensor Kit P/N 01535
Including items below:
10’ Extension Cable
M/P 150 P/N 13206
14” Nylon cable ties (5)
P/N 10045
5’ Run/Hold Sensor Cable
P/N 13226
Hardware Bag
P/N 13251
Speed Sensor
Mounting Bracket
P/N 10013
Magnets - 6
(2 in hardware bag)
P/N 10012