Page 20
optoCONTROL EDU190
5.
Software
5.1
Basic Settings
The digital display is configured to automatically detect the connected sensor type and to adjust the user
interface accordingly. It does not matter whether the digital display is connected via the RS232/RS422 con-
nection or the Ethernet connection.
The set standard IP is 169.254.168.150.
i
For automatic detection via Ethernet, the sensor should be set to the standard IP address. You can also
change the sensor IP address in the address field.
If connection problems occur with Ethernet, please check whether the sensor has been set to the standard IP
address. If necessary, reset the sensor to factory settings.
In order to use a different IP address of the EDU190, please contact the MICRO-EPSILON Eltrotec GmbH
support
, see 7
.
i
When using the RS232/RS422 serial interface, the standard baud rate of the respective optoCONTROL
ODC must be used. If connection problems occur, use the baud rate of the respective factory settings.
In order to use a different setting of the serial interface, please contact the MICRO-EPSILON Eltrotec GmbH
support
, see 7.
Some changes that are selected via the web interface of the ODC 2520 sensor or the ODC 12XX software will
not take effect until the digital display is restarted.
Disconnect the display from the power supply.
Restart the digital display when you need to change the controller settings.
i
Refer to the respective operating instructions for the sensor settings.
The software can be set in German or English and has several buttons for the visualization, configuration and
retrieval of sensor data.
