Page 23
optoCONTROL EDU190
Master value (1)
To reset or master the display value to a desired value, use a master value. Press the
Set master value
button to confirm. This represents a one-point calibration of the displayed value. When mastering, the devia-
tion from the unmastered measured value is displayed as offset in millimeters. Pressing the
Reset master
value
button deletes the value.
Settings IP address (2)
Pressing the
Set default IP address
button confirms the desired IP address. With an active serial con-
nection, the network address settings are not displayed.
To set a new IP address for the sensor, click in the
Network address
field to enter the new IP address.
Language setting (3)
Press the respective button (German or English flag) to set the desired language.
Circumference calculation (4)
Circumference calculation is only available with the diameter measurement. Setting the
checkmark
activates
the circumference calculation. The mastered or unmastered measurement value is then multiplied with PI and
output as circumference value.
