Page 35
Liability for Material Defects
optoNCDT ILR2250
11.
Liability for Material Defects
All components of the device have been checked and tested for functionality at the factory. However, if defects occur
despite our careful quality control, MICRO-EPSILON or your dealer must be notified immediately.
The liability for material defects is 12 months from delivery. During this period any defective parts, with the exception of
parts subject to wear, will be repaired or replaced at no cost when sent to MICRO-EPSILON. Any damage that is caused
by improper handling, the use of force or by repairs or modifications by third parties is not covered by the liability for
material defects. Repairs are carried out exclusively by MICRO-EPSILON.
Further claims can not be made. Claims arising from the purchase contract remain unaffected. In particular, MICRO-EP-
SILON shall not be liable for any consequential, special, indirect or incidental damage. In the interest of further develop-
ment, Micro-Epsilon reserves the right to make design changes without notification. For translations into other languag-
es, the German version shall prevail.
12.
Service, Repair
If the sensor or sensor cable is defective:
-
If possible, save the current sensor settings in a parameter set,
see
> Save parameters to a file
, to reload them into the
sensor after the repair,
-
Please send us the affected parts for repair or exchange.
If the cause of a fault cannot be clearly identified, please send the
entire measuring system to:
MICRO-EPSILON Eltrotec GmbH
Manfred-Wörner-Straße 101
73037 Göppingen / Germany
Tel. +49 (0) 7161 / 98872-300
Fax +49 (0) 7161 / 98872-303
e-mail [email protected]
www.micro-epsilon.com
13.
Decommissioning, Disposal
Remove the connection cables from the sensor.
Incorrect disposal may cause harm to the environment.
Dispose of the device, its components and accessories, as well as the packaging materials in compliance with the
applicable country-specific waste treatment and disposal regulations of the region of use.
