Page 44
Anhang | ASCII Communication with Sensor
optoNCDT ILR2250
A 3.6.3 SETDEFAULT, Factory Settings
SETDEFAULT MEASSETTINGS
Resets the sensor to factory settings.
-
ALL: Deletes the measurement and device settings and loads the standard presets for the measurement settings and
default parameters for the device settings.
-
MEASSETTINGS: Deletes the measurement settings and loads the standard presets.
-
BASICSETTINGS: Deletes the device settings and loads the default parameters.
A 3.6.4 LASER
LASER [OFF|ON|MEASURE]
-
OFF: Switches the laser off, ends the measurement.
-
ON: Switches the laser on for installation purposes; no measurement.
-
MEASURE: Starts a measurement.
A 3.6.5 ROI, Region of Interest
ROI [<lower> <upper>]
Sets the region of interest; the value range for min and max is between the SMR and EMR. The value “min <lower>” is
less than the value “max <upper>”.
<lower> Value range between SMR and EMR (mm, one decimal place)
<upper> Value range between SMR and EMR (mm, one decimal place)
A 3.7
Data Output
A 3.7.1 OUTPUT
OUTPUT [NONE|RS422|RS422_ASCII]
Output of measurement results to serial interface.
-
NONE: No output of measured values.
-
RS422: Binary output of measured values via RS422.
-
RS422_ASCII: Output of measured values via RS422 using ASCII.
A 3.7.2 GETOUTINFO_RS422, Data Selection Query
GETOUTINFO_RS422
The command lists all output data selected for the RS422 interface. The order shown corresponds to the output order.
A 3.7.3 OUTADD_RS422, Data Selection of Additional Values
OUTADD_RS422 NONE|([TIMESTAMP])
Selection of additional values to be transmitted.
-
NONE: No output of any further values
-
TIMESTAMP: Output of the time stamp
A 3.7.4 ANALOGSCALERANGE
ANALOGSCALERANGE [<lower> <upper>]
Sets the scaling limits for the analog output during two-point scaling.
Value range:<limit 1> = (-2 ... +2) * Measuring range [mm] <limit 2> = (-2 ... +2) * Measuring range [mm]
The scaling limits must not be identical;
<lower>
is less than
<upper>
.
<lower> Value range between SMR and EMR (mm, one decimal place)
<upper> Value range between SMR and EMR (mm, one decimal place)
