Micom ALSTOM P341, Technical Data Sheet

Page: 16 / 62

P341 Technical Data Sheet
14
P341 Software versions 36 & 71J
Surge withstand capability
Per IEEE/ANSI C37.90.1: 2002:
4 kV fast transient and 2.5 kV oscillatory
applied directly across each output contact,
optically isolated input, and power supply
circuit.
4 kV fast transient and 2.5 kV oscillatory
applied common mode to communications,
IRIG-B.
Surge immunity test
(EIA(RS)232 ports excepted).
Per IEC 61000-4-5: 2005 Level 4,
Time to half-value: 1.2 / 50 µs,
Amplitude: 4 kV between all groups and
protective (earth) conductor terminal.
Amplitude: 2 kV between terminals of each
group.
Immunity to radiated electromagnetic
energy
Per IEC 60255-22-3: 2000, Class III:
Test field strength, frequency band 80 to 1000
MHz:
10 V/m,
Test using AM: 1 kHz / 80%,
Spot tests at 80, 160, 450, 900 MHz
Per IEEE/ANSI C37.90.2: 2004:
80 MHz to 1000 MHz, 1 kHz 80% AM and AM
pulsed modulated.
Field strength of 35 V/m.
Radiated immunity from digital
communications
Per EN61000-4-3: 2002, Level 4:
Test field strength, frequency band 800 to
960 MHz, and 1.4 to 2.0 GHz:
30 V/m,
Test using AM: 1 kHz/80%.
Radiated Immunity from Digital Radio
Telephones
Per IEC 61000-4-3: 2002:
10 V/m, 900 MHz and 1.89 GHz.
Immunity to conducted disturbances
induced by radio frequency fields
Per IEC 61000-4-6: 1996, Level 3,
Disturbing test voltage: 10 V.
Power frequency magnetic field immunity
Per IEC 61000-4-8: 1994, Level 5,
100 A/m applied continuously,
1000 A/m applied for 3 s.
Per IEC 61000-4-9: 1993, Level 5,
1000 A/m applied in all planes.
Per IEC 61000-4-10: 1993, Level 5,
100 A/m applied in all planes at 100 kHz/
1 MHz with a burst duration of 2 s.
Conducted emissions
Per EN 55022: 1998 Class A:
0.15 - 0.5 MHz, 79 dB
μ
V (quasi peak)
66 dB
μ
V (average)
0.5 - 30 MHz, 73 dB
μ
V (quasi peak) 60 dB
μ
V
(average).
Radiated emissions
Per EN 55022: 1998 Class A:
30 - 230 MHz, 40 d B
μ
V/m at 10 m
measurement distance
230 - 1 GHz, 47 dB
μ
V/m at 10 m
measurement distance.
EU directives
EMC compliance
Per 2004/108/EC:
Compliance to the European Commission
Directive on EMC is demonstrated using a
Technical File. Product Specific Standards
were used to establish conformity:
EN50263: 2000
Product safety
Per 2006/95/EC:
Compliance to the European Commission
Low Voltage Directive. (LVD) is
demonstrated using a Technical File.
A product specific standard was used to
establish conformity.
EN 60255-27: 2005
R&TTE compliance
Radio and Telecommunications Terminal
Equipment (R & TTE) directive 99/5/EC.
Compliance demonstrated by compliance to
both the EMC directive and the Low voltage
directive, down to zero volts.
Applicable to rear communications ports.
ATEX compliance
ATEX Potentially Explosive Atmospheres
directive 94/9/EC, for equipment.
The equipment is compliant with Article 1(2) of
European directive 94/9/EC.
It is approved for operation outside an ATEX
hazardous area. It is however approved for
connection to Increased Safety, “Ex e”, motors
with rated ATEX protection, Equipment
Category 2, to ensure their safe operation in
gas Zones 1 and 2 hazardous areas.
CAUTION - Equipment with this marking is not
itself suitable for operation within a potentially
explosive atmosphere.