Prodomus
22
Put the sausage filling into the filling tray.
Switch the ON/OFF switch into position OFF to ensure that the appliance is switched off.
Then plug in.
Now switch the ON/R switch into position „ON“ and the big silver switch to the left into
position “I” to switch the appliance ON.
The Sausage filling will get pressed through the sausage filling attachment into the
sausage gut. When the desired length of sausage has reached, switch off the appliance,
press the gut and turn at the same time for a few times. Repeat the same way till the end
of the gut is reached almost. Then switch off the appliance, pull off the end of the gut form
the sausage filling attachment and knot it.
TIP:
Sausage will expand while cooking or freezing. So never overfill the gut otherwise the
sausage can burst.
When you have read all details of chapter „Processing sausage“ you can use the appliance
as described above.
Working with the „Kebbe“ attachment
The Kebbe attachment is the Kebbe disc (11) together with the Kebbe ring (13) which is
put onto the Kebbe disc . With the attachment you can form hollow rolls from food (e. g.
dough, meat or vegetables) which you can fill as desired.
First press the meat through the desired mincing disc for two times (as described under
„Processing meat“) before you start to press it through the Kebbe attachment.
Making of rolls needs practice. The consistency of the mixture may not be to dry neither
too wet. Concentration of fluid of food is very different, it is not possible to specify or to
provide any guidelines. The right mixing ratio can be made by own experience only. Use
commercial recipes as a basis for comparison.
When you have read all details of the topic Kebbe attachment you can use the appliance
as described above.
Caution! Always switch off (power switch position “0”) the appliance immediately
and unplug after each use.
After each use clean the unit thoroughly because it is in contact with food.
Trouble shooting
If the drive is blocked by jamming food:
Put the big silver switch in to position “medium” to stop the unit.
Now press the ON / OFF switch into position „ON“ then press the REV switch function. The
drive now runs backward in pulse function. With this function you can transport the food
backward to get the drive free again. When the drive is free release the switch.
Press the ON / OFF switch into position „ON“ and the big silver switch on the left side to
position “I” to restart the appliance.
If the drive cannot be released after processing as described above clean the appliance as
described in chapter „Cleaning , maintenance and storing”.
If the unit gets overheated:
Short term operation of
3 min
(see „Technical data and short term operation“) may not be
exceeded. In case of non-observance the unit and the motor could get damaged by overheating.
Switch off the unit after 3 minutes of permanent operation and let it cool down for 30 min. before
using again.
