Mhouse RT3N, Installation And Use Instructions And Warnings

Page: 11 / 136

English – 9
EN
Table [E] Memorizing additional transmitters in
Mode II Example
1 Press and hold down the desired key on
the new transmitter (New TX) until you
hear a beep (after about 5 seconds) then
release it New TX
2
Within 5 seconds, press and hold down
for approx. 5 seconds a previously
memorized key on a transmitter (old TX)
until you hear 2 short beeps, then release
the key Old TX
3
Within 3 seconds, press again the same
key on the previously memorized
transmitter (old TX) as many times as the
number corresponding to the desired
command: 1 = Step-By-Step; 2 = Open;
3 = Close; 4 = Stop Old TX
4 After approx. 3 seconds you will hear a
number of beeps corresponding to the
selected command
5
Within 2 seconds, press again the
desired key on the new transmitter (new
TX) to confirm the programming New TX
The 3 final beeps signal that the new transmitter has been correctly memorized.
If the memory is full (30 transmitters), 6 beeps will signal that the memory is not
capable of memorizing any additional transmitters.
5s
5s
X1...X4
X1...X4