Mhouse RT3N, Installation And Use Instructions And Warnings

Page: 8 / 136

6 – English
EN
Even if one or more transmitters have already been memorized in Mode I,
additional transmitters can be memorized in Mode I, as described in Table
[B] .
Table [B] Memorizing additional transmitters
in Mode I Example
1 Press and hold down key
n
of the new
transmitter to be memorized (New TX)
until you hear a beep (after about 5
seconds) then release i
New TX
2 Press key
n
of a previously memorized
transmitter (old TX) slowly 3 times
Old TX
3 Once again, press and release the key on
the new transmitter you pressed
according to step 1 New TX
The 3 final beeps signal that the new transmitter has been correctly memorized.
If the memory is full (30 transmitters), 6 beeps will signal that the memory is not
capable of memorizing any additional transmitters.
5s
ADDITIONAL INFORMATION
— STEP 6 —
This chapter examines the various memorisation possibilities of the RC1
receiver 1.
Memorization in Mode II (advanced memorization)
In this mode, one of the 4 available commands can be associated to each
transmitter key, as shown in Table
[C] .
In this mode, the memorization procedure is performed separately for each
single transmitter key; this means that 2 keys on the same transmitter can be