Mhouse MhouseKit WS2S, Installation Instructions Manual

Page: 27 / 36

25
Type
Adopted technology
Lamp
Power supply
Ambient operating
temperature
Use in particularly acid, saline or
potentially explosive atmospheres
Assembly
Protection rating
Dimensions / weight
Type
Adopted technology
Detection capacity
TX transmission angle
RX reception angle
Useful capacity
Power supply/output
Power absorption
Maximum cable length
Routing possibility
Ambient operating
temperature
Use in particularly acid, saline or
potentially explosive atmospheres
Assembly
Protection rating
Dimensions / weight
PH100 photocells
Presence detector for automations of automatic gates and doors (type D according to standard
EN 12453) comprising a transmitter “TX” and receiver “RX
Optical, by means of direct TX-RX interpolation with modulated infrared ray
Opaque objects located on the optical axis between TX and RX, larger than 50mm and moving
slower than 1.6 m/s
approx. 20°
approx. 20°
Up to 10m for maximum TX-RX misalignment of ± 5° (the device can signal an obstacle even in
the case of adverse weather conditions)
The device can be connected only to “ECSBus” networks from which it receives the power supply
and sends the output signals
1 ECSBus unit
Up to 20 m (observe the directions regarding the minimum gauge and type of cable)
Up to 7 detectors with protection function and 2 with open command function
Automatic synchronism avoids the interference among the various detectors
-20 ÷ 50°C
No
Vertical, wall-mounted
IP44
64 x 89.2 h 29 mm / 60 g
Indicator light FL100
Flashing signalling light for automatic gates and doors. The device incorporates a receiving aerial
for remote control
Visual signalling device with 12V 21W lamp, controlled by MHOUSE automation control units
12V 21W BA15 socket (automotive type lamp)
The device can only be connected to the “FLASH” and “ARIEL” terminals of the MHOUSE auto-
mation control units
-20 ÷ 50°C
No
Horizontal surface-mounted or vertical wall-mounted
IP44
120 x 60 h 170mm / 285g