23
Fig. 13-1.
CAUTION: THE DECORATIVE HEAT SHIELD WILL BE HOT
DURING AND AFTER OPERATION.
LIGHTING TEST
Prior to proceeding with installation, perform a lighting test (see
lighting instructions for lighting your burner). Allow the unit to
completely cool after testing.
LAVA GRANULES/COALS (DECORATIVE)
1.
Spread the supplied lava granules on the floor of the appliance,
around the front and sides of the burner system (see Fig. 13-2).
The lava granules may be placed around the switch box. Leave
the front of the switch box clear for control access.
2. Repeat this process for the supplied lava coals (on top of the
already placed lava granules).
Note: DO NOT place any lava media on the burner system, or
behind it.
IMPORTANT
For all valves, the air MUST be purged from the gas line before the pilot will light and burn properly. The time needed
to purge will depend on the length of the gas line to the unit and the amount of time since the unit or gas line was
last used. It may take several minutes before all the air is purged and the pilot will light and burn properly. Reference
the LIGHTING INSTRUCTIONS section in this manual.
