Sys*Stim 240 Instruction Manual — Rev.I_09/23/19
29
4.3 Quick Set-up for Electrical Stimulation
1.
Turn on the mains power switch located on the back of the unit by
pressing dot on the switch to the “On” position.
Image shows
switch in “Off” position.
2.
Press either “1” or “2” to select channel one or two. Please note
that Interferential mode requires both channels.
3.
Insert the electrode cable into the channel connector for the
channel that you will be using.
4.
Place the electrodes on the patient.
5.
Insert the patient safety cable into the jack located on the back of
the unit and hand the end with the button to the patient letting
him/her know that they can push this button at any time during
the treatment to stop it.
6.
If all of the parameters are set correctly
(The default treatment
mode is Interferential.)
press enter and then use the M Wheel by
dragging your finger in a clockwise direction to adjust the intensity
up. You will notice that if two channels are being used, they will go
up simultaneously. The intensity in the digital display will go up
and the green bar will get larger as the intensity increases. Moving
your finger around the M Wheel in a counterclockwise direction
will decrease the intensity. The time will begin to count down until
the treatment is complete. A buzzer will sound and the end-of-
treatment message will appear.
If you want to adjust just one channel in a 2-channel operation,
drag your finger clockwise on the M Wheel and channel 1 will be
highlighted and then channel 2. To select one to adjust, press enter
and then adjust the intensity. If you press enter again, you can go
to the other channel to adjust it independently.
7.
These instructions are an overview of how to start a treatment
quickly. For more details about each waveform, go to its specific
instructions.