23
• Go in MENU /
Edit / Edit CH.
• Press the yellow key, the Add channel pops up.
• On the
Satellite
line, select the satellite with
34
arrows.
• On the
TP
line, select with
34
arrows the TP that carries the channel to add. If the TP is not
listed, you must add it in the Edit TP menu as explained above in this manual.
• On the
Channel
line, press OK to display the window
allowing to edit the channel name.
• To write a letter at the cursor location, press the 0-9
keys as you would do with a cellular mobile phone (for
example, press twice the key 3 to write a E). Press the
4
arrow to edit the next letter, press one of the color
keys to insert or delete a letter. Press OK when your
edition is over.
• Press OK and check that the signal is correct (Signal
Quality >50%). Should the opposite occur, you will have
to check again the technical parameters, or check the
DiSEqC settings in the LNB setup menu.
• On the
Search Type
line, select
TP
with
34
arrows.
• On the
FTA/CAS type
line, select
FTA
with
34
arrows.
• Go to the
Search Current ANT
line and press OK. The
Search channels
window appears, and
the newly found channels are listed and sotred.
• Press OK and then EXIT to quit the menus.
• On the next 3 lines enter the
Video PID
, the
Audio PID
and the
PCR PID
. The
PCR PID
is
usually equal to
Video PID
for a TV channel, and equal to
Audio PID
for a radio channel.
• Go down to Store line and press OK to save.
• The channel is add at the bottom of the channel list.
F - Add a satellite
If the channel is broadcast by a satellite which is not factory pre-programmed, you need to create
the satellite before making any channel addition on this satellite.
• Go in MENU /
Edit / Edit SAT.
• Press the yellow key, the
Add
channel pops up.
• On the
Satellite
line, press OK to display the window allowing to edit the satellite name.
• To write a letter at the cursor location, press the 0-9 keys as you would do with a cellular mobile
phone (for example, press twice the key 3 to write a E).
Press the 4 arrow to edit the next letter, press one of the
color keys to insert or delete a letter. Press OK when your
edition is over.
• On the
Angle
line, input the position of the satellite (eg 130
for Hotbird) and select East / West with
34
arrows.
• In the
Frequency, Polarity
and
Symbolrate
lines, enter
the data of a valid TP for the present satellite.
• Go down to
Store
line and press OK to save.
• The channel is add at the bottom of the channel list.
