12
Alignment of the dish
• Install the monobloc on the dish arm as
depicted on the figure
• Align the dish on HotBird as explained in the
previous paragraph
• Check that you receive channels from both
Astra and HotBird
• If not, adjust the alignment to receive perfectly
both satellites.
Attention,
some
models
of
monobloc may have a reverse
setting. In that case, you must
change the programming of the
receiver (Astra on input port 1 and
HotBird on input port 2).
B - Installation of a DiSEqC 1.0 switch
If you install 2 or more dishes, or 2 LNB on the same dish, you must connect all the LNB to
a switch, featured with one single output, allowing to run one cable between the dish and the
receiver. For the installation, align each dish / each LNB just as if it was alone, connecting
directly this LNB to the receiver with one cable, without any switch. Once all the dishes are
aligned, install the switch and alter the settings of the receiver to properly drive the switch.
