14
G
5) Memorised the Hotbird position
(7)
6) With the Continuing rotation
(4)
then a step by step rotation
(5)
, bring the motor
precisely at the 0° position.
7) Switch off the receiver, take off the cables and then fix the motor on the top end of the
support.
8) Direct approximately the motor towards the south. In case of an assembling on a wall,
make sure the wall faces south (to within about 20°) and use a 45cm stand off arm at
least (ref: 450359): see schema F2.
9) Connect the receiver and the motor by the long wire prepared at the step D.
F2
Satellite dish assembling
Assemble the different elements from the satellite dish in checking the user manual inclu-
des with it.
• For the METRONIC satellite dish in metal 77-80cm (Four holes), the satellite dish back
support should be adjusted at 54° (check the picture above).
• For the 85cm Transparent Metronic satellite dish, adjusted the elevation at the
maximum (45°)
• For another satellite dish, try 48°, but you might have to try some other value if you
have any problem with the alignment.
(4)(5)(7)
See the paragraphs on the
page 9.
H
I
