2-28
Metro
®
AccessPoint™ Mobile Computing System Operator Manual
Revision 1.0
LO1-530
Getting Started: Wake on LAN / Wake on Power
4. Select “System Configuration”, “Device Configurations” and “Wake on
LAN”. Check “Follow Boot Order” as shown below.
5. Save BIOS changes and boot the computer into Windows.
6. Press the SYNC button to acquire the computer's MAC address.
7. The standby button's light will fl ash rapidly. Once the MAC address is
acquired, the light will go solid for 3 seconds, off for ½ second and then
stay on due to the computer's current draw.
8. If the Keypad Controller was not able to acquire the MAC address, the
standby button's light will fl ash rapidly for several seconds and then it
will go off or 3 seconds, on for ½ second and then stay on due to the
computer's current draw. If the sync fails, most likely the Ethernet cable
is not plugged into the computer and/or the Keypad Controller.
9. Open the Windows Device Manager.
a.
Under Network Adapters, select the Ethernet connection (Typically
it is an Intel Gigabyte Network Connection).
b. Right click and select “Properties”.
c.
Click on the “Power Management” tab.
