Metasys N2, Technical Manual

Page: 65 / 67

N2 Dialer Module—N2 Dialer Module (NDM) 65
Table 23: CS Object and NDM Point Mapping
Local or
Remote
NDM
Hardware
Reference
Command
Flag
Can Be Mapped
to Software Model
Attributes
Description Range
Local ADI1 No AD, MS
(advised MS)
Connection Status 0 = idle
1 = dialing
2 = connected
3 = retry
4 = failed
Local ADI65 Yes AD, MS
(advised MS)
Dial Command - phone
number index to be
dialed (0-50) -1= remote connect
0 = disconnect
1-50 = phone number index
Local ADI66 Yes AD, MS
(advised MS)
Disconnect Delay
Control - when to
disconnect 0 = normal disconnect delay
1 = 4.0 hour delay
2 = never hang up
Both BD66 Yes AD Number of retries for
dialing 0-100
Both BD67 Yes AD Dial Delay - number of
minutes between
successive retries 1-30
Local BD68 Yes AD Disconnect Delay -
number of minutes to
wait before
disconnecting 1-255
Both BD69
Yes AD Modem Connect Time -
maximum time in
seconds to wait for the
modem to connect 30-255
Remote BD70 Yes AD Online Poll Count -
number of online
devices to poll before
offline devices (applies
to D00 firmware
controllers only) 1-255
Remote BD71 Yes AD Offline Poll Count -
number of offline
devices to poll before
online devices. (applies
to D00 firmware
controllers only) 1-255
Remote BD72 Yes BD Remote NDM Dial In
Control 0 = dial in on alarm COS
1 = no dial in on alarm COS
Remote BD73
Yes AD Idle Timeout - after a
dial in, the remote NDM
will hang up if no N2
communication is
detected for the duration
of the idle timeout 1-255
Point Mapping
Table