Metaphase Technologies Metaphaser MP-LE1007, Operating Manual

Page: 7 / 35

Quick Start - Setup Menus - DC Version
Follow the steps below to quickly set up the High-Power DC Metaphaser for basic
operation using the Metaphaser keypad: Press the M button on the front panel to select
each Menu screen and then press
the ▼ or ▲ buttons to select within each specific menu.
1. Apply 12V power to the unit by setting toggle switch on the rear of the unit to the ON position.
2. After applying power to the device, the boot-up screen will flash and display the Model
name. At the bottom left you will find the current Driver Version:
3. When prompted, choose Yes to enter the Setup Menus.
*If setup prompt is missed at startup, the unit can be prompted to enter the setup menu at any
time by pressing the
M
and ▼ ▲ buttons simultaneously. Scroll through the various menus using
the M button located on the Metaphaser front panel.
•
Light Level Intensity Limit
– sets the maximum Light Level output level (in percent) for which
the LED is rated or to limit the range in the run-time menu. Default setting is 100%.
•
Trigger Polarity
– Used to define the edge of the trigger pulse the system uses to turn on the
LED output. Rising edge is default, which is typical for most users.
If “Trigger Polarity” is set to
“RISING”, then the output will be ON when a voltage is present at the trigger input. If “Trigger
Polarity” is set to “FALLING”, then the output will be ON when a voltage is NOT present at the
trigger input. This only applies when the Metaphaser
’s “Trigger Controls DC = Yes”.
Metaphase LED Light Engine
Model#: MP
-
LE1007 Model#: MP
-
LE1007
Trigger Polarity
Chan 1 Rising
LightLevMax=100%
Metaphaser-1
7.4