11
OPERATION MANUAL
F
ig
.3.2
3. Put the press frame in an upright position,
attach the 2 x upper cross beams (10) to left
and right main posts (20) using bolts M16 x
35 (9), M16 washers (13), M16 spring
washers (12) and M16 nuts (11). The upper
cross beam with the Metalmaster logo is to
be facing the front of the press. (Fig.3.2)
4. Tighten all frame bolts
5. Attach the sliding plate (7) to the upper
cross beams, with the handle hook side
facing the front of the press. Using the 4 x
M8 x 20 bolts, flat and spring washers.
(Fig.3.3)
6. Screw the upper round nut (6) onto the ram
(3), insert the ram into the hole in the under
plate (7), then screw the under round nut (8)
onto the ram and attach the serrated saddle
(5) to the ram. (Fig.3.4)
7. Join the two press bed frame (18) together
by inserting the four bolts M10 x 140 (27)
through the bushings (28) and the holes in
the bed frames, then secure the four bolts
by tighten the M10 washer (14), M10 lock
washer (15) and M10 nut (16) on it. (Fig.3.5)
8. Insert bed frame pin (19) into the holes in
the posts, then insert the joined press bed
frame (18) into press frame and onto bed
frame pin. Use the retaining clip (35) to
secure the pins in place.
F
ig
.3.5
F
ig
.3.3
F
ig
.3.4
