10
OPERATION MANUAL
The position where your machine is operated is important for safe operation and the longevity
of its components. For best results, operate this machine in a dry environment that is free from
excessive moisture, hazardous chemicals, airborne abrasives, or extreme conditions.
Extreme conditions for this type of machinery are generally those where the environment is
subject to vibration, shocks, or bumps.
Children or untrained people may be seriously injured by this machine. Only install in an
access restricted location.
Lighting around the machine must be adequate enough that operations can be performed
safely.
Consider the largest size of workpiece that will be processed through this machine and provide
enough space around the machine for adequate operator material handling or the installation
of auxiliary equipment.
3. INSTALLATION
3.1 ASSEMBLY
Ensure the press and its components suffered no damage during transit and that all the parts
are present. Should any loss or damage become apparent, please contact your local dealer
immediately.
IMPORTANT: Due to the weight of the press components, we recommend that you get
assistance during assembly.
IMPORTANT: Do not locate your press where it will be open to the elements, as severe weather
conditions will damage the hydraulic parts.
Use the spare part exploded drawing on page 23 as your guide to assemble.
Lay all parts and assemblies out in front of you before beginning.
Loosely attach all frame parts first then once the frame is all assembled tighten all the fasteners.
The following procedure is recommended:
1.
Attach one base section (21) to a main
post (20) and lower cross member (26)
using bolts M12 x 35mm (25), washers
M12 (22), spring washers M12 (23) and
nuts M12 (24), then attach the other
post to the opposite side of the lower
cross member, using the same fasteners
as above. (Fig.3.1)
2.
Attach the 4 x Support bars (34) to the
base section (21) and the main posts (20)
using bolts M10 x 25mm (33), washers
M10 (14), spring washer M10 (15) and
nuts M10(16). (Fig.3.1)
F
ig
.3.1
