Metallkraft 3814001, Operating Instructions Manual

Page: 9 / 18

Transport, packaging and storage
SBM-Series | Version 2.02 9
5 Transport, packaging and storage
5.1 Delivery and transport
5.1.1 Delivery
After delivery, check the bead bending machine for vi
-
sible transport damage. If the bead bending machine
shows any damage, this must be reported immediately
to the transport company or the dealer.
All packaging must be removed; the corresponding in
-
structions in this operating manual for installation must
be read. Possible transport damage must be immedi
-
ately documented photographically for the purpose of in
-
surance benefits.
To avoid accidents, the necessary precautions must be
taken when unloading and transporting the machine.
See the chapter on safe handling of this machine.
5.1.2 Transport
5.2 Packaging
All packaging materials and packaging aids used in the
machine are recyclable and must always be recycled.
Cardboard packaging components must be shredded for
collection of waste paper.
The foils are made of polyethylene (PE) and the uphol
-
stery parts made of polystyrene (PS). These substances
must be handed over to a recycling center or to the re
-
sponsible disposal company.
5.3 Storage
The bead bending machine must be thoroughly cleaned
before it is stored in a dry, clean and frost-free environ
-
ment.
5.4 Placement
In order to achieve good functionality and a long service
life of the bead bending machine, the installation site
should meet the following criteria:
- The underground must be even, solid and vibration-
free.
- The machine should be firmly anchored to ensure a
safe stand.
- There must be sufficient space for the operating per
-
sonnel, for material transport and for adjustment and
maintenance work.
ATTENTION!
When transporting and lifting the bead bending
machine make sure that the transport and lifting
equipment can support the load.
WARNING!
Risk of fatal injury!
If the weight of the machine and the permissible load
capacity of the lifting equipment are not observed
during transport or lifting work, the machine may tip
over or fall.
Use protective gloves!
Wear safety boots!
CAUTION!
Danger of crushing!
The bead bending machine can tilt during installation
and lead to serious injuries.