6
SBM-Series | Version 2.02
Safety
2.7 Safety instructions for the use of tools
Please note the following:
1. Use only bending rollers that are not deformed or da
-
maged.
2. Only use original bending rollers.
3 Replace deformed and damaged bending rollers im
-
mediately. Use of the machine is prohibited until the
bending rollers have been replaced.
4. Always use bending rollers adapted to the workpiece.
5. Only use bending rollers with suitable sizes.
6. Check the drive components of the bending rollers for
contamination. Clean the clamping area of the ben
-
ding rollers before assembly.
2.8 Safety Instructions for processing
Please note the following:
1. Use the machine only for carrying out the intended
work.
2. Do not use the machine for purposes for which it is not
intended, such as bending brittle materials.
3. Observe the maximum dimensions of the workpieces
specified in the technical data (see chapter "Technical
data").
4. Do not overload the machine. It works better and safer
in the specified performance range. Do not use the
machine for heavy work that requires a more powerful
machine.
5. Check the stability of the machine and the secure bol
-
ting to the foundation.
6. Note that the use of tools and accessories other than
those recommended by the manufacturer may result
in injury.
7. Do not leave any tools inserted. Before switching on,
check that all repair and adjustment tools have been
removed.
8. Do not leave the machine unattended during machi
-
ning and keep a sufficient safety distance from the
moving machine parts.
9. Only start the machine if the bending rollers can run
freely.
10. If the bending rollers are blocked during machining by
clamping the workpiece, stop the machine.
11. Workpieces may only be clamped or removed when the
bending rollers have come to a complete standstill.
2.9 Safety measures for maintenance and
servicing
Please note the following:
1. During maintenance and repair work, always switch
off the machine at the main switch and take suitable
measures to secure it against being switched on again
by unauthorised persons.
2. After maintenance, repair and cleaning work, check
that all covers and protective devices have been pro
-
perly installed on the machine and that no tools are
left inside the machine or in the machining area.
3. Damaged safety devices, machine parts and switches
must be replaced or repaired by an approved specia
-
list workshop.
4. Only original spare parts may be used. Otherwise
there is a risk of accident for the operator.
2.10 Safety label on the beading machine
A safety label is attached to the bead bending machine
which must be observed and followed. The safety mar
-
king placed on the bead bending machine must not be
removed. Damaged or missing safety markings can lead
to wrong actions, personal injury and material damage.
They must be replaced immediately. If the safety mar
-
king is not immediately visible and understandable, the
bead bending machine must be taken out of operation
until the new safety marking has been affixed.
Fig. 1: Safety label - Rotating parts
Summary of Contents for 3814001
Page 18: ...www metallkraft de ...
