9
•
This menu enables use of a hands-free unit (if present).
•
If “YES” is selected, further menus will also appear for its configuration
(e.g.: “Sounder volume” etc..)
•
Possible selections
NO
÷
YES
•
To modify the setting, press
+
or
-
.
•
To confirm and exit, press
OK
•
To cancel and exit, press
C
HANDS FREE KIT 364
Installer OK
Select function :
Handsfree set
Present ? NO
Installer OK
Select function :
VOL 1 input pol.
NEGATIVE
VOL1 INPUT POLARITY 362
•
This menu is used to set the polarity of the signal coming from the
vehicle’s alarm.
•
Refer to the alarm’s instruction manual for details regarding its
polarity (NB: MetaSystem products have negative polarity!).
•
Possible selections:
NEGATIVE
÷
POSITIVE
•
To modify the setting, press
+
or
-
.
•
To confirm and exit, press
OK
•
To cancel and exit, press
C
Installer OK
Select function :
Max VOL1/2
alarms: 10
MAX NUMBER OF VOL1/2 ALARMS 427
•
This menu is used to set the maximum number of times that an alarm
can be triggered on the vehicle. Calls will not be placed after the set
amount.
•
The counter is reset when the ignition key is switched off and on again.
•
If this parameter is set at 0, alarms triggered on the VOL1 input will not
be transmitted.
•
Possible selections:
0
÷
254
•
To modify the setting, press
+
or
-
.
•
To confirm and exit, press
OK
•
To cancel and exit, press
C
EXTERNAL ALARM IMMUNITY 429
Installer OK
Select function :
•
This menu is used to set the time that must pass before the device
will rearm and so can accept a new alarm signal. It will not place any
calls during this set time.
•
The counter is reset when the ignition key is switched off and on
again.
•
Possible selections:
0 ÷ 15
(minutes)
•
To modify the setting, press
+
o
-
.
•
To confirm and exit, press
OK
•
To cancel and exit, press
C
Extern alarm
immunity 0 min
Installer OK
Select function :
GSM Call activ.
delay 3
DELAY TO ACTIVATE GSM CALL 341
•
The number represents the pause after which the alarm call will be
placed. Taking the example given opposite, the call will be placed after the
device has detected the alarm signal for at least 3 seconds.
•
Possible selections:
0
÷
254
(seconds)
•
To modify the setting, press
+
o
-
.
•
To confirm and exit, press
OK
•
To cancel and exit, press
C
Summary of Contents for GPA600
Page 1: ...INSTALLATION AND PROGRAMMING INSTRUCTION MANUAL Pager GPA600 GPA800 V810690A ...
Page 4: ......
Page 19: ...NOTES ...
Page 20: ......
