Meta System GPA600, Installation And Programming Manual

Page: 12 / 20

12
Installer OK
Select function :
Vehc. Plate
(8 chs.)
Vehc. Plate
(8 chs) AM184NT
Done
VEHICLE NUMBER PLATE 307
• The number plate can be composed of maximum 8 digits.
• To enter a letter, press the relevant key on the Sat Programmer
repeatedly until it is displayed
• To confirm and go on to the next digit, press the + key; a dot “ • “ will
appear on the display next to the digit you have just entered.
• Press the - key to delete the digit you have just entered
• To confirm and exit, press OK
• To cancel and exit, press C
NB :
Please remember that the vehicle’s full number plate will only be given
in SMS format; voice messages only give its numbers.
Enter letters and
numbers
CAR ALARM CALLS LIST 353
• IThis menu is used to programme the calls that will be placed should
the vehicle’s alarm be triggered.
• The maximum number of calls is 5. It is possible to send the message
to 5 different telephone numbers.
• The telephone numbers for these calls are selected by entering the
position in the phonebook where they have been stored previously
• The format for the call must also be set, i.e. the method used to place
the call. There are 4 possible configurations:
VOICE : the call is made by means of a synthesised voice message
SMS : the call is made by means of a SMS text message (only for
mobile phones!)
SMS+VOICE : the call is made firstly by means of a SMS text message
and this is immediately followed by a voice message.
VOICE/SMS : the call is made by means of a voice message; if this
does not receive any reply, a SMS text message is sent.
• To select the phonebook position, simply enter its number.
• The call will not be placed if a phonebook position ( Pos. - - ) is not keyed
in.
• For the two dashes, press the “0” key until “ - - “ appears..
• To programme the format used to place the call, use the
▲
and
▼
keys.
• To programme in the number of the call, use the + and - keys.
• To confirm and exit, press OK .
• To cancel and exit, press C
NB :
If this is the first list to be programmed in, the request “Copy this to all
call list?” will appear when you press OK to exit.
If you press OK , the settings you have just made for this list will also be
stored in all the other lists.
An interim display will appear:
“Function active. Please wait”
If, however, you do not want the configuration of all the lists to be the
same, simply press
C and then programme each list individually.
Installer OK
Select function :
Calls list editor
CAR ALARM
CAR ALARM < 1 >
Pos. - - VOICE
CAR ALARM < 1 >
Pos. 81 VOICE
CAR ALARM < 1 >
Pos. 81 SMS
CAR ALARM < 3 >
Pos. - - VOICE
CAR ALARM < 3 >
Pos. 10 VOICE
CAR ALARM < 3 >
Pos. 10 VOICE / SMS
See N.B.
+
-
OK
OK
Key in the
phonebook position
Key in the
phonebook position
OK to store