Car Bed Accessories
Locking Clip
Two locking clips provided with car
bed as a standard part.
Replacements available.
(See Page 49)
Page 10
Installation Video
Available Upon Request.
(Page 49).
Medical Tube Control Strap
Provided with car bed as a standard
part.
Replacements available.
(See Page 49)
Buckle Pad
Provided with car bed as a standard
part.
Replacements available.
(See page 49)
Securing Child in 3-Point Harness
NOTE: Verify that the cummerbund
and 3-point harness have been
installed according to Pages 20 - 23.
Important:
Child must be at least 10
pounds and not more than 35
pounds to use the 3-pt harness. The
large cummerbund must also be
used with the 3-point harness.
1. Open cummerbund and 3-pt
harness (Fig. A).
2. Place child in car bed. Place
large cummerbund firmly
around child. Fasten Velcro in
place (Fig. B).
3. Lengthen harness by lifting the
lever (See arrow—Figure C)
located at lower end of
bottom cushion under
fabric flap (Fig C) and pull
harness to desired length.
4. Place shoulder straps over the
shoulders. Connect buckle and
chest clip. Cummerbund will
provide cushion between child
and buckle/chest clip (Fig. D).
Note: Proceed to Step 5
on next page.
Page 43
A
B
D
3-Point Harness
with cummerbund
Weight Range:
Over 10 Pounds to
35 Pounds
Height Range:
Car bed will transport
a child up to 29 inches in height. If
the child’s legs are permitted to
bend, the car bed can transport a
child taller than 29 inches.
C
