Attaching Cummerbund and 3-Point Harness, Cont.
ASSEMBLY
3-Point Harness Installation
1. Open cushion flap and insert
buckle anchor into buckle slot
(Fig. I).
2. Lock buckle anchor in place from
the bottom (Fig. J).
3. Push both shoulder straps
through the top slots in the bot-
tom cushion (Fig. K) and then
through mating slots (second
from top) in plastic shell (Fig. L).
4. Turn the car bed on its side and
continue to pull the shoulder
straps through the bottom of the
shell (Fig. L).
I
J
Page 22
K
L
Top Slots (Cushion)
Bottom of Plastic Shell
Locking the Vehicle Lap Only Belt
INSTALLATION
Page 31
Option 4—Locking Lap Belt
1. After buckling the vehicle lap
belt, press your hand down
on the car bed and remove as
much slack from the lap belt
as possible by pulling the
belt’s free end (Figure I).
2. Determine if the car bed is
secure as described in the
section “Checking the Stability
of the Car bed” below. If nec-
essary, repeat Step 1 until the
car bed is secure.
Verify that the car bed does not move more than one inch in
any direction when you grasp it near the belt path and at-
tempt to move it side to side and front to back. The car bed
must remain securely installed in order to protect your child
in a crash. Check your car bed frequently for a tight fit.
Checking the Stability of the Car bed
I
NOTE: The car bed must be installed using 2 vehicle seat belts.
