Attaching Cummerbund and Restraint Bag
Page 14
ASSEMBLY
Cummerbund Installation
NOTE: Installation of the cummer-
bund and restraint bag must be
done before installing the car bed
in vehicle.
1. Remove the 1 ½” and 1/2” side
EPS panels (Figure A) to expose
the attachment slots (Fig. A).
2. Cummerbund must be positioned
with the identification label right
side up (When facing child, care-
giver should be able to read cum-
merbund label (Fig. B).
3. Insert the metal anchor on right
side of cummerbund into the side
attachment slot (Fig. C). Lock an-
chor in place from the bottom
(Fig. D).
D
A
C
Head end
of Car Bed
B
Page 39
Leveling of Car Bed, Cont.
INSTALLATION
5. Repeat Steps 2-4 for the lev-
eling strap on the other side
of the car bed.
6. Tighten both leveling straps
by pulling on the free end of
each strap (Figure E).
7. Figure F shows the car bed
with the leveling straps in-
stalled.
E
F
NOTE: If it is not possible to use the
leveling straps, then the optional
Leveling Wedge may be used in-
stead.
1. Simply center the wedge under-
neath the car bed with the thick
end against the vehicle seat
back (Figures G and H) prior to
the installation steps on Page
33.
2
Proceed with the installation
steps on Page 32.
H
G