10
26
EQUIPMENT SET-UP
Tower Trainer
™
Owner’s Manual
8
Safety & Usage
Sliding Stability Bar Adjustment
To adjust the height of the Sliding Stability Bar [30], pull out
on the spring-loaded pins [29] and carefully slide the bar to the
desired location. Release the pins and ensure they are fully locked
in one of the holes. The bar also comes with a soft padded
covering to increase comfort and usability.
NOTE:
Always make sure that the sliding stability bar holders
[7, 28] are adjusted so the bar is parallel with the mat.
Set-Up For The Push-Thru Bar
Attach the push-thru bar [25] to the top adjustment hole
in the uprights [10, 24] with two upper push-pins [26].
Attach the safety chain [3] to the eyehook [1] on the top of the
upper tube assembly [2]. For some exercises, the push-thru bar
[25] should be up and secured in position with the safety chain
[3]. The push-thru bar [25] can be used as a foot bar for some
exercises. Attach the push-thru bar (25) to the lowest adjustment
hole in the upright [10, 24] with two upper push-pins [26].
Lock the push-thru bar [25] to the uprights [10, 24] with
two lower push-pins [26].
NOTE:
w
There are three adjustment holes in the uprights that allow you
to attach the push-thru bar [25] at one of the different heights.
w
Refer to the inset illustration. Push down the button on the “T”
end of the push-pins [26] to release. Then you can insert
the push-pin [26] into the adjustment hole.
w
Always make sure the safety chain [3] is connected when the
push-thru bar [25] is in use in the rotating positions.
1
.
2
.
3
.
29
.
28
.
25
.
24
.
30
.
7
.
