12
ATTACH THE OPENER AND DETERMINE THE POSITION OF THE GATE BRACKET
10
1. Bring the gate to the closed position.
2. Align the holes on the opener to the post bracket holes. Attach the opener to the post bracket using the bolts and nuts in figure 1.
3. Attach the gate bracket to the articulated arm using the clevis pin & hairpin clip in figure 2.
4. Release the opener manual release with the release key, see section 9.
5. Position the gate bracket as shown in figure 3.
6. Temporarily secure the gate bracket to the gate leaf and opener to the gate bracket.
7. Manually open and close the gate to the required positions. Ensure the opener arm does not bind. When opening and closing
position are OK proceed with Step 8. If there is an issue with the desired opening position, change the gate bracket position or
check if the A, B and C dimensions of the post bracket were chosen correctly.
NOTE: Be sure that during the manual
movement from close to open and vice versa there is no obstruction or impact of the arm against the leaf or pillar.
8. Close the gate and re-engage the release mechanism.
9. Fasten the gate bracket to the gate in the correct position chosen.
.
14 mm
figure 1
figure 2
figure 3
INSTALLATION
DISENGAGEMENT OF THE MANUAL RELEASE
9
1. Remove the small front plastic cover from the opener (figure 1).
2. Put the key into the keyhole and turn right (figure 1).
3. Pull the lever down (figure 2).
NOTE: To re-engage the opener, follow the procedure in reverse.
figure 1
figure 2
