15
OPENER CONNECTION 1 AND 2
14
NOTE: The opener wired to the MOTOR1 terminal, will always open first and close last.
The Primary opener is already pre-wired to MOTOR1 terminals. No extra steps required for MOTOR1 wiring.
figure 1
NOTE: The opener wired to MOTOR2 terminal, will always open last and close first.
1. Connect the extension cable (not provided) to the wiring terminals of the Secondary opener.
The cable colours of the Secondary opener should match the control board wiring terminal for MOTOR2.
2. Feed the Secondary opener extension cable through one of the cable glands at the bottom of the Primary opener. Ensure that the
cables will not be cut by the opener of the arm during operation.
3. Connect the Secondary opener cables to the MOTOR2 terminals as follows:
• Red cable to RED terminal
• Green cable to GRN terminal
• White cable to WHT terminal.
WIRING
POWER WIRING
15
Power Wiring
Mains power
wiring must be
done by a certified
electrician.
figure 1
Power Wiring
1. Connect the pre-assembled mains power plug to the nearby general purpose power outlet.
2. Tighten the IP rated gland.
