13
PROGRAMMING
TIMER TO CLOSE FEATURE (TTC)
17
PROGRAM TRANSMITTERS TO THE OPENER LIGHT
18
Auto close is NOT recommended for households with young children.personal injury from a closing garage
door.
The door may operate unexpectedly, therefore do not allow anything to obstruct the path of the door.
SAFETY FIRST!
Whilst Merlin have engineered safety features into your garage door opener, we urge you to consider
fitting The Protector System
TM
(IR Beams) to your new garage door opener. In many countries these
devices are compulsory to assist in preventing serious injury or property damage. For your own peace of
mind and the safety of others please consider installing this safety device.
TIMER TO CLOSE feature: (TTC) 10 to 180 seconds.
NOTE: The Protector System
TM
(IR Beams) MUST be installed before TTC will operate.
The Timer to Close feature allows the door to automatically close after a specified time period. During the OPEN door waiting
period, the courtesy light will flash continuously.
If the door encounters an obstruction while closing, the opener will return to the OPEN
position and the TTC will begin again.
To activate the Timer to Close:
• Start with The Protector SystemTM (IR Beams) installed and the door fully
CLOSED.
• Press and Hold both “P” and “DN” buttons for 3 seconds. When the Courtesy light
flashes “TWICE”, release both buttons.
• Press the “UP” for each 10 second interval required for
Timer to Close. A “BEEP” will register for each press. “DN” button will reduce the
count if needed.
• Press and release the “P” button to accept this setting.
To deactivate the Timer to Close:
• Start with the door fully CLOSED.
• Press and Hold both “P” and “DN” buttons for 3 seconds. When the courtesy light
flashes “TWICE”, release both buttons.
• Press and release the “P” button to accept this setting.
To program your transmitters to operate your garage door opener light follow the
below steps:
NOTE: Do not use the same transmitter button that has been previously
learned to the garage door opener for operation.
1. Press and release the “S” button, and the “courtesy light” will flash twice
(fig.1).
2. Press and release the “P” button and the garage door opener will go into
courtesy light learn mode for 30 seconds (fig.2).
3. Press any transmitter button (fig.3) to learn this channel to the garage door
opener courtesy light, the garage door opener "courtesy light" will flash twice.
The transmitter is now learnt to the garage door opener courtesy light.
To Erase all Transmitter Codes
1. Press and hold the “S” button on the opener until the courtesy light flashes
twice, and continue holding for approximately 8 seconds, until the courtesy
light flashes twice again.
2. Release the button, all transmitter codes are now erased.
DN
DN UP
UP P
P
S
S
1
1
2
2
3
3
132A2940
DN
DN UP
UP P
P
S
S
1
1
2
2
3
3
132A2940
Flash
x 2
BEEP
BEEP
ACTIVATE
TIMER TO
CLOSE
SET
TIME
DN
DN UP
UP P
P
S
S
1
1
2
2
3
3
132A2940
Flash
x 2
BEEP
ACCEPT
SETTING
or
DN
DN UP
UP P
P
S
S
1
1
2
2
3
3
132A2940
DN
DN UP
UP P
P
S
S
1
1
2
2
3
3
132A2940
Flash
x 2
