16
PROGRAMMING
INSTALLING YOUR E148M FOUR BUTTON WIRELESSWALL MOUNT REMOTE
24
Disconnect power to the opener whilst installing this
accessory to prevent accidental activation. Locate
minimum 1.5 m above the floor
WIRELESS PROGRAMMING (REMOTE ACCESSORIES)
23
NOTE: The transmitters supplied with your opener are preprogrammed by
the factory.
If you purchase additional transmitters, the garage door opener must be
programmed to accept the new transmitter code.
Program the receiver to match additional transmitter codes:
Using the “S” SAVE Button
1. Press and hold the button on the transmitter that you wish to use (1).
2. Press and release the “S” button on the opener (2).
3. Release the transmitter button when the courtesy light flashes twice. It has
learnt the code. If you release the transmitter button before the opener light
flashes, the opener has not learnt the code.
The opener will now operate when the transmitter button is pressed.
To Erase all Transmitter Codes
1. Press and hold the “S” button on the opener until the courtesy light flashes
twice, and continue holding for approximately 8 seconds, until the courtesy
light flashes twice again.
2. Release the button, all codes are now erased.
Activate the opener only when door is in full view, free
of obstruction and properly adjusted. No one should
enter or leave the garage while the door is in motion.
Do not allow children to operate push buttons or
remotes. Do not allow children to play near the door.
1
2
DN
DN UP
UP P
P
S
S
1
1
2
2
3
3
132A2940
Flash
x 3
BEEP
or
2
3
4
3
Press and release
the yellow
“S” save button
Enter a 4-digit
PIN of your
choice
? ? ? ?
_ _ _ _
Press and hold
the enter button
Opener light bulbs
blink
After the lights
blink release the
ENTER button
1
Locate
the yellow
“S” save button
DN
DN UP
UP P
P
S
S
1
1
2
2
3
3
132A2940
DN
DN UP
UP P
P
S
S
1
1
2
2
3
3
132A2940
BEEP
Flash
x 2
To install:
• Carefully pry open the E148M and locate the two screws for mounting.
• Attach to the wall using the two screws and wall anchors provided if mounting
to a plaster wall. If using a recessed wall box do not use anchors.
NOTE: Do not overtighten screws.
NOTE: The wall control supplied with your opener should be pre-programmed by the factory.
If adding a new wall control, program into the opener before mounting the unit as detailed in the “Wireless
Programming” section.
1
2
