Customising the analogue controller
17
To configure a source
●
Switch off the analogue controller, using the power switch on
the back panel.
●
Switch on the power again while holding down the Display
key on the front panel.
The display will show:
Config
●
Press Source until the left-hand pair of characters identifies
the source you want to configure.
For example, to configure the CD
source the display initially shows:
CD CD
●
Press Copy (front panel), or
>
>
>
>
>
and
<
<
<
<
<
(remote), to step
between options.
The right-hand pair of characters shows the current value of the
option.
The options are summarised in the table shown on the next
page.
To change an option
●
Press
A
or
V
to step between the alternative values for the
option.
When you have finished programming sources:
●
Switch off the analogue controller, using the power switch on
the back panel.
●
Switch on again to restore normal operation.
