Customising the analogue controller
14
Choosing standard settings
The 502 Analogue Controller provides three alternative standard
settings, called Types, which configure all aspects of the
analogue controller into the three most commonly needed
configurations.
Choosing one of the six standard settings overrides any other
configuration you may have performed, and so can be used to
reset the configuration of the analogue controller.
By default, the analogue controller is supplied set to Type 1.
If you have a system containing only Meridian 500 Series units
then you should choose Type 1 or 3. Choose Type 3 if you are
using the analogue controller in the second room of a two-room
system.
If your system includes any Meridian 600 or 200 Series units you
should choose Type 2. For more information see To connect to
Meridian 600 or 200 Series equipment, page 28.
To select a standard setting
●
Switch off any power amplifiers that are connected to the
analogue controller.
●
Switch off the analogue controller, using the power switch on
the back panel.
●
Switch on the power again while holding down the Off key on
the front panel.
The display will show:
Type
It will then show:
Type 1
●
Press
V
V
V
V
V
or
A
A
A
A
A
to change the type number.
For example, to select Type 3
the display shows:
Type 3
●
Switch off the analogue controller, using the power switch on
the back panel.
●
Switch on again to use the standard settings you have
selected.
