Section 1 - Getting Started
Page 6
90-8M0120668
eng
MARCH 2016
3. Install the mounting adapter as shown below.
a -
Mounting adapter
b -
Gasket
c -
Nylon nut
d -
Air temperature sensor
4. Thread the sensor into the mounting adapter.
5. Connect the temperature sensor to the connector on the VesselView harness.
Maintenance
IMPORTANT: It is recommended that the supplied sun cover be installed for protection when the unit is not in service.
Display Screen Cleaning
Routine cleaning of the display screen is recommended to prevent a buildup of salt and other environmental debris. Crystalized
salt can scratch the display coating when using a dry or damp cloth. Ensure that the cloth has a sufficient amount of fresh water
to dissolve and remove salt deposits. Do not apply aggressive pressure on the screen while cleaning.
When water marks cannot be removed with the cloth, mix a 50/50 solution of warm water and isopropyl alcohol to clean the
screen. Do not use acetone, mineral spirits, turpentine type solvents, or ammonia based cleaning products. The use of strong
solvents or detergents may damage the anti‑glare coating, the plastics, or the rubber keys.
It is recommended that the sun cover be installed when the unit is not in use to prevent UV damage to the plastic bezel and
rubber keys.
Media Port Cleaning
The media port door area should be cleaned on a regular basis to prevent a buildup of crystalized salt and other debris. A red
rubber composite plug inside the micro SD card port helps prevent water intrusion into the card port.
IMPORTANT: Install the plug after cleaning, or after updating the software.
NOTE: Install the plug with the groove side up. The opposite side has a chamfer so the door does not collide with the plug.
52721
Stuck Buttons
Verify that there are no buttons stuck in the down position. If a stuck button is found, wiggle the button to free it.
a
b
c
d
10738
