Mercury Pinpoint GPS, Manual, Page: 21 / 32

Storing or Overwriting an Anchor Position
a - Memory buttons (1–8)
NOTE: An anchor position can be stored or overwritten from any operating
mode except route record mode.
To store an anchor location, press and hold any of the numbered
memory
buttons for two seconds. The unit will emit a tune to indicate that the anchor
position has been stored successfully.
A stored anchor position can be overwritten by simply storing a new anchor
position to the desired
memory
button.
Recalling a Stored Anchor Position
NOTE: A stored anchor position can be recalled from any operating mode.
To recall a stored anchor position, press and release the desired
memory
button. The trolling motor will emit an ascending chirp to indicate that a stored
anchor position has been retrieved. If the selected anchor position button does
not have a stored anchor position, or if the anchor location is over one mile
away from your current location, the trolling motor will emit an error tone.
IMPORTANT: If the trolling motor loses the GPS signal while in any GPS
mode, the trolling motor will emit an error tone and automatically return to
manual mode.
IMPORTANT: When recalling a stored anchor position, the system will
calculate a straight‑line course from your current position to the selected
anchor position. Ensure that there are no obstructions to navigation between
your location and the selected anchor position—the system will recall an
anchor point even if obstructions are present. If obstructions are encountered,
navigate around them by operating in manual mode.
54420
a
PRODUCT INSTALLATION AND OPERATION
eng
17