Mercury 225 EFI, Service Manual

Page: 456 / 719

POWER TRIM - DESIGN II
Page 5B-30 90-884294 OCTOBER 2001
IMPORTANT: Cross pin should not be reused. Replace with new cross pin.
NOTE: 6 trim mounting bolts should not be reused. Replace with new patch lock bolts.
6. Drive out cross pin, push out upper swivel pin, and remove 3 bolts and washers in port
clamp bracket.
58452
b
b
a
a
58444
c
a - Cross Pin
b - Upper Swivel Pin
c - Port Transom Bracket Bolts and Washers (3). Remove to release Trim
System from Outboard.
7. Remove 3 bolts and washers and in starboard transom bracket.
58453
a
c d
a
b
a - Transom Mount Bolts (2)
b - Tilt Tube Nut (flush with end of thread)
c - Screws (3)
d - Washers (3)
8. Remove outboard transom mounting bolts and loosen tilt tube nut until nut is flush with
end of tilt tube thread. Remove system from outboard.