Mercury 225 EFI, Service Manual

Page: 486 / 719

POWER TRIM - DESIGN II
Page 5B-60 90-884294 OCTOBER 2001
Reassembly - Motor and Pump
NOTE: Drive shaft is a loose part and may fall out of position.
1. Install pump into power trim manifold. Insure O-rings are in proper locations. Secure
with 3 screws. Torque screws to 60 lb. in. (7 N·m).
58609
a
b
a - Oil Pump
b - Screws (3) Torque to 60 lb. in. (7 N m)]
IMPORTANT: Install pump with location flat facing towards starboard transom
bracket.
2. Fill pump with ATF Dexron III or Power Trim and Steering Fluid prior to installing motor.
3. Install motor, secure with 2 screws. Torque screw to 80 lb. in. (9 N m). Route wiring;
refer to Wiring Diagrams in this service manual.
NOTE: Verify motor and drive shaft are aligned.
58610
b
58611
a
a
c
a - Motor
b - O-ring
c - Screw (2) Torque to 80 lb. in. (9 N m).